Pixhawk 2.4.8 Flight ControllerSKU 5006

Quadcopter & Drones

Pixhawk 2.4.8 Flight Controller

₹5,999

01 — About

What it does

The Pixhawk 2.4.8 Flight Controller is an advanced open-source autopilot system for drones, rovers, and boats. It features a 32-bit ARM processor, multiple sensors, and support for MAVLink protocol for autonomous navigation and stabilization.

Key features

  • 32-bit ARM Cortex-M4 processor at 168MHz
  • Triple-redundant IMU (2x accelerometer + 3x gyro)
  • Barometer for altitude hold
  • Multiple flight modes including GPS, loiter, RTL
  • MAVLink protocol for ground station communication
  • SD card slot for logging and parameter storage
  • Multiple UART ports for GPS, telemetry, OSD

Good to know

  • Requires GPS module for position hold and autonomous modes
  • Install Mission Planner or QGroundControl for configuration
  • Calibrate accelerometer, compass, and radio before first flight
  • Motor PWM outputs are not servo-compatible – use servo rail for servos
  • Safety switch must be pressed before arming
  • Always test in ANGLE (self-leveling) mode before acro/rate mode

02 — Datasheet

Specifications

12
Processor
STM32F427 Cortex-M4 168MHz
Sensors
MPU6000 + L3GD20 + LS303D + MS5611
Flash Memory
2MB
SD Card
MicroSD (up to 32GB)
UART Ports
5
PWM Outputs
14
Analog Inputs
3
CAN Bus
2 ports
I2C
2 ports
Operating Voltage
5V (servo rail), 3.3V (logic)
Firmware
PX4, ArduPilot (APM)
Dimensions
50mm x 80mm x 15mm