L298N Dual H-Bridge Motor Driver Module | DC & Stepper Motor Controller for Arduino & Raspberry PiSKU 8002

Motor Driver & Shield

L298N Dual H-Bridge Motor Driver Module | DC & Stepper Motor Controller for Arduino & Raspberry Pi

₹140

01 — About

What it does

The L298N Dual H-Bridge Motor Driver Module | DC & Stepper Motor Controller for Arduino & Raspberry Pi is a dual H-Bridge motor driver capable of controlling two DC motors or one stepper motor. It features high current capacity and an on-board voltage regulator for logic supply.

Key features

  • Dual H-Bridge design controls 2 DC motors or 1 stepper
  • 2A per channel continuous current (3A peak)
  • 5V-35V motor voltage range
  • Onboard 5V regulator for logic supply
  • Current sensing pins for overload detection
  • Schottky diode protection against back EMF
  • Heat sink included for thermal management

Good to know

  • Enable jumpers must be in place or PWM pins used for speed control
  • L298N has ~2V voltage drop – motor sees less than supply voltage
  • Heat sink required at currents above 1A per channel
  • Do not exceed 25W total dissipation
  • 5V output available only when motor supply >7V
  • For better efficiency at low voltages, consider DRV8833

02 — Datasheet

Specifications

08
Model
L298N
Motor Voltage
5V – 35V
Logic Voltage
5V – 7V
Max Current
2A per channel (3A peak)
Total Power
25W
Control Pins
ENA, ENB, IN1-IN4
Protection
Overheating, overcurrent
Dimensions
43mm x 43mm x 27mm